Motors / Servos

*BZZZZZZZZZZ* Feel that? That's your little buzzing motor, and for any haptic feedback project you'll want to pick up a few of them. These vibe mot...

A stepper motor to satisfy all your robotics needs! This 4-wire bipolar stepper has 1.8° per step for smooth motion and a nice holding torque. The ...

This range makes them perfect for controlling with an Adafruit Motor Shield, or with an Arduino where you are more likely to have 5 or 9V available...

This NEMA 17-size hybrid bipolar stepping motor has a 1.8° step angle (200 steps/revolution). Each phase draws 1.7 A at 2.8 V, allowing for a holdi...

This module is a compact breakout board for ST’s high-power VNH5019 motor driver IC, a fully integrated H-bridge that can be used for bidirectional...

Hobby Gearmotor - 200 RPM (Pair)

These are perhaps better known as "the drivers in our assembled Adafruit Motorshield or Motor HAT." We really like these dual H-bridges, so if you ...

Add more power to your robot with this metal-geared servo. The tiny little servo can rotate approximately 180 degrees (90 in each direction), and w...

These small brushed DC gearmotors can deliver a lot of power for their size. This version has a 6V brushed DC motor combined with a 56:1 metal spur...

This breakout board for Freescale’s MC33926 full H-bridge has an operating range of 5 V to 28 V and can deliver almost 3 A continuously (5 A peak)...

Texas Instruments’ DRV8835 is a tiny dual H-bridge motor driver IC that can be used for bidirectional control of two brushed DC motors at 2 to 11 V...

OverviewThis product is a carrier board or breakout board for Allegro’s A4988 DMOS Microstepping Driver with Translator and Overcurrent Protection;...

This gearmotor is a miniature high-power, 6 V brushed DC motor with long-life carbon brushes and a 29.86:1 metal gearbox. It has a cross section of...

To control with an Arduino, we suggest connecting the orange control wire to pin 9 or 10 and using the Servo library included with the Arduino IDE ...

Comes with one mount and a bag of hardware for attachment: 4 x 34mm long M4 Pan head 4 x M4 washer + lock (spring) washer + hexnut 4 x 9mm...

Power requirements: 4 to 6 VDC* , 15 -200 mA Communication: Pulse-width modulation Dimensions: 2.2 x 0.8 x 1.6 in (55.8x 19 x...

50:1 Micro Metal Gearmotor with Extended Motor Shaft

This gearmotor is a miniature medium-power, 6 V brushed DC motor with a 51.45:1 metal gearbox. It has a cross section of 10 × 12 mm, and the D-shap...

The FS5103B is a general-purpose, low-cost standard analog servo from FEETECH. Two ball bearings help reduce friction and improve performance. Serv...

This NEMA 23-size hybrid stepping motor can be used as a unipolar or bipolar stepper motor and has a 1.8° step angle (200 steps/revolution). Each p...

OverviewThe AR-3606HB is a standard-sized servo that has been built by Power HD specifically for continuous rotation. At 6 V, it has a maximum rota...

Voltage: 12VNo-Load performance: 10,000 RPM, 150mAStall extrapolation: 0.5kg.cm, 5.5A

Concentric LACT12-12V-20 Linear Actuator: 12" Stroke, 12V, 0.5"/s

This gearmotor is a powerful brushed DC motor with 131.25:1 metal gearbox intended for operation at 12 V. The gearbox is composed mainly of spur ge...

Description: Faster, cheaper, smaller, better, right? The SN754410 Quad Half H-Bridge is just that. Capable of driving high voltage motors using TT...

he HD-3001HB is a great general-purpose, standard-size servo. Two ball bearings help reduce friction and improve performance. The lead is terminate...

Run four solenoids, two DC motors or one bi-polar or uni-polar stepper with up to 600mA per channel using the L293D. These are perhaps better known...

The driver has a pinout and interface that are nearly identical to those of our A4988 stepper motor driver carriers, so it can be used as a higher-...

Good for beginners who want to make stuff move without building a motor controller with feedback & gear box, especially since it will fit in sm...

You want to make a cool Arduino robot, maybe a hexapod walker, or maybe just a piece of art with a lot of moving parts. Or maybe you want to drive ...

Like our original carrier, the Black Edition offers adjustable current limiting, over-current and over-temperature protection, and five different m...