Your shopping cart is empty or products are not available any more.
0 reviews / Write a review
Note: This sensor needs a 4.7K ohm pull-up resistor. Make sure you have one in hand...
Description: This basic piezo sensor from Measurement Specialties is often used for flex, touch..
1: Digital White LED Light Module project2: Piranha LED Light Module3: 3W LED Module4: RGB LED modul..
This pressure transducer has a range of 0 - 10000 PSI (1723.69 kPa) and an a..
This pressure transducer has a range of 0 - 500 PSI (1723.69 kPa) and an accuracy..
We've now got a wider range version of favorite triple-axis accelerometer - it even has an on-board ..
These spring-vibration switches are high sensitivity non-directional vibration induced trigger swit..
Triple-axis analog accelerometer - for measuring motion and tilt
Force sensitive r..
The QTR-3RC reflectance sensor array is intended as a line sensor, but it ca..
Pulse Sensor Amped adds amplification and noise cancellation circuitry to the hardware. It's noticea..
Operating voltage: 2.7 V to 6.2 VAverage current consumption: 5 mA (typical)Output ty..
The GP2Y0A60SZ distance sensor from Sharp offers a wide detection range of 4″ to 60″ (10 cm to ..
Runs on 5V-16V power (if you need to run it off of 3V you can do that by bypassing the regulator, bu..
Detects a wide range of colors and outputs data as 10-bit RGB (Red/Green/Blue) componen..
This compact sonar range finder by Maxbotix detects objects from 0 to 6.45 m (21.2 ft) wit..
Using the MaKey MaKey you can make anything into a key (get it?) just by connecting a few alligator ..
KWD 27.50 KWD 22.00
This board is a compact (0.4″ × 0.9″) breakout board for ST’s LSM6DS33 inertial module, which featur..
These pressures can easily be converted to altitudes. The board has a 3.3 V linear regulator and int..
The Leap Motion Controller is a fascinating new computer sensor that uses multiple cameras and IR li..
This board is a compact (0.4″ × 0.9″) breakout board for ST’s L3GD20H three-axis digital-output gyro..
This is a pre-wired and waterproofed version of the DS18B20 sensor made with a PTFE wire cable. Hand..
Take your project portable with the included battery pack and stitch it into a final design with con..
Secure your project with biometrics - this all-in-one optical fingerprint sensor will make adding fi..
The Sensor Film Kit is a great new way to make custom-sized sensors out of force sensitive material...
These lightweight brackets are made from 0.8mm-thick aluminum and are specifically designed to work ..
This pressure sensor from Freescale is a great low-cost sensing solution for precision measurement o..
The pre-programmed Touch Board is Arduino-at-Heart, so your Arduino shields and code will work seeml..
Decode nearly any kind of 1D (striped) barcode in your project using this adorable compact barcode s..
An anemometer is a device used for measuring wind speed, and is a common weather station instrument...
This GPS shield works great with either UNO or Leonardo Arduinos and is designed to log data to an S..
It's summer and you're sweating and your hair's all frizzy and all you really want to know is why th..
This current sensor is a carrier board or breakout board for Allegro’s ACS711KLCTR-25AB-T Hall effec..
This current sensor is a carrier board or breakout board for Allegro’s ACS711KLCTR-12AB-T Hall effec..
This current sensor is a carrier board or breakout board for Allegro’s ACS709LLFTR-35BB-T..
The eTape Liquid Level Sensor is a solid-state sensor with a resistive output that varies with the l..
Description: A simple flex sensor 4.5" in length. As the sensor is flexed, the resistance acros..
This board is a compact (0.5″ × 0.9″) breakout board for ST’s L3GD20 three-axis digital-ou..
Put a current meter anywhere with this very handy display. This panel meter requires a DC voltage to..
The Sharp distance sensors are a popular choice for many projects that require accurate di..
This force-sensing resistor (FSR) from Interlink Electronics is a passive component that acts as a v..
This sensor can detect flexing or bending in one direction. They were popularized by being used in t..
These sensors are easy to use, they are basically resistors that change value based on how much thei..
This flammable gas and smoke sensor detects the concentrations of combustible gas in the a..
This methane gas sensor detects the concentration of methane gas in the air and ouputs its ..
New! Version 3 comes with the latest module which has external antenna support and Pulse-Per-Second ..
It is designed to be submersible in water, but it's always best to avoid long-term (over 1 hour at ..
This set includes sensor boards and reflective wheels to add quadrature encoding to two mi..
This Photo Transistor Light Sensor is a simple sensor that detects ambient light. It's kind of the o..
The Pixy CMUCam 5 is an image sensor with a powerful processor that you can program to only send the..
The QTR-3A reflectance sensor array is intended as a line sensor, but it can ..
Operating Voltage: 2.5 V to 5.5 V
Carrier Frequency: 38 kHz
The X-Band Motion Detector operates in the X-band frequency, at 10.525 GHz and indicates detected mo..
These spring-vibration switches are high sensitivity non-directional vibration induced trigger switc..
The "poor man's" accelerometer/motion sensor! These spring-vibration switches are medium sensitivity..
For specific temperature-to-resistance, check the lookup table.
These are often ..
This is a bare wires bead-probe which can measure air or surface temperatures. Most inexpensive the..
The AM2302 is a wired version of the DHT22, in a large plastic body. It is a basic, low-cost digital..
Wide range, low power temperature sensor outputs an analog voltage that is proportional to the ambie..
DescriptionThe eTape Liquid Level Sensor is a solid-state sensor with a resistive output that varies..
Description: The SparkFun Soil Moisture Sensor is a simple breakout for measuring the moisture ..
Description: Piezo elements come in handy when you need to detect vibration or a knock. You can..
Feature:1.Working Voltage : 5V(DC)2.Static current: Less than 2mA..
Description: A simple flex sensor 2.2" in length. As the sensor is flexed, the resistance acros..
This allows a microcontroller with an analog-to-digital converter (ADC), such as an Arduino&nbs..
This breakout board will solve all your current-monitoring problems. Instead of struggling with a mu..
This load sensor, sometimes called a strain gauge, is the same one found in digital bathroom scales ..
Kit Listing:White LED Module * 1RGB LED Module *13W LED Module &n..
keyestudio XD-58C pulse sensor module is used to measure heart rates. It’s widely applied for studen..
Our water sensor is easy- to-use, portable and cost-effective, it is designed to identify and detect..
keyestudio GUVA-S12SD 3528 Ultraviolet Sensor is used to detect ultraviolet light. It includes GUVA-..
This sensor adopts TCS3200 programmable color light-to-frequency converter, it can be applied to col..
The AD8232 is an integrated front end for signal conditioning of cardiac bioelectrical signals to mo..
This cyber-tronic looking sensor hides a secret behind its glimmering eye. Unlike most temperature s..
The SparkFun Load Sensor Combinator is a bare PCB that combines four load sensors into a standard fo..
Operating voltage: DC 5VQuiescent current: 5mA. Farthest distance: 4.5m.The device is waterproof, bu..
This 16-character, 2-line parallel liquid crystal display achieves a large viewing area in a compact..
KWD 3.75 KWD 2.75
For a long time we’ve had small 7-segment displays and huge 7-segm..
KWD 1.50 KWD 1.00
Educational robot by Parallax. Learn more from Parallax here!
KWD 49.00 KWD 45.00
OWI’s second-generation robotic arm kit, the Robotic Arm Edge, teaches the basic mechanics and elect..
KWD 27.75 KWD 23.00
KWD 6.00 KWD 4.50
The ELEV-8 Quadcopter is a flying robotic platform that is lifted and propelled by four fixed rotors..
KWD 182.00 KWD 145.00
The S2 robot is suitable for a wide range of programming skills. The Scribbler robot arrives pre-pro..
KWD 45.00 KWD 38.00
KWD 21.00 KWD 18.00
The AR-3606HB is a standard-sized servo that has been built by Power
HD specifically for..
KWD 5.25 KWD 4.50
he HD-3001HB is a great general-purpose, standard-size servo. Two ball bearings help reduce friction..
KWD 5.00 KWD 4.00
The FS5103B is a general-purpose, low-cost standard analog servo from FEETECH. Two ball bearings hel..
KWD 4.50 KWD 3.50
Description: Resistors are a good thing, in fact, they’re actually crucial in a lot of circuit desig..
KWD 4.75 KWD 3.75
KWD 9.75 KWD 6.75
A solid state relay (SSR) allows you to control high-curent AC loads from lower voltage DC control ..
This 20-character, 4-line parallel liquid crystal display provides a large viewing area. It features..
KWD 4.95 KWD 3.25
Brief DescriptionThe ESP8266 WiFi Module is a self contained SOC with integrated
TCP/IP protocol s..
KWD 4.00 KWD 2.50
Brief DescriptionThe ESP8266 WiFi Module is a self contained SOC with integrated TCP/IP protocol sta..
KWD 7.00 KWD 4.50
Feather is the new development board from Adafruit, and like its
namesake it is thin, light, and l..
KWD 9.50 KWD 7.00
While this chip has been very popular, its also been very difficult to use. Most of the low cost mod..
KWD 8.75 KWD 7.00
Add a mini printer to any microcontroller project with this very cute thermal printer. Thermal print..
KWD 16.75 KWD 15.50
KWD 3.00 KWD 2.50
KWD 0.75 KWD 0.45
KWD 0.75 KWD 0.50
The Boe-Bot Robot takes about 1-2 hours to put together. Each project in the Robotics text provide..
KWD 49.00 KWD 44.00
Enter your Email and you will be notified once item will be again available.
We ship to the GCC and MENA regions.
Reliable and fast shipping to your door, quality assured.
Find us on Instagram
Just type @idea_link